PUBG Mobile Sensitivity Generator
Camera, ADS and gyro for every scope, tuned to your phone, frame rate and finger layout. Works for BGMI too.
1 Your phone
2 How you play
More options (for pro players)
Balanced suits most players. Rush and Sniper only shift close or far scopes by a few %.
3 Your sensitivity
Why these numbers
How to test them
Go to Training Grounds with your main gun. Pick a scope below, aim at one spot and hold fire for the whole magazine while pulling down. Then tap what happened. Repeat until it says Perfect.
Everything feels off?
If all scopes feel too fast or too slow, change them together (5% per tap).
Setting it up in game
- Open Settings → Sensitivity. Enter the Camera table first, then ADS, then Gyroscope and ADS Gyroscope.
- Set the frame rate in Settings → Graphics to the same value you chose above, because the numbers depend on it.
- Go to Training Grounds and spray an M416 (compensator + vertical grip) at a wall from 50 m with each scope.
- Then open the "Fix after testing" tab: tell it what each scope did and it corrects only that scope, a smaller step each time, until your spray is a laser.
FAQ
What is the best PUBG sensitivity for iPhone?
iPhone 13 Pro and newer Pro models run PUBG at 90-120 FPS on 120 Hz screens, which allows slightly higher camera values than 60 Hz phones. Search your exact iPhone above and the generator applies its screen size and refresh rate automatically.
Should I use gyro "Always on" or "Scope only"?
Always on gives the fastest tracking but needs practice; Scope only keeps thumb aiming for turns and uses gyro just for recoil while scoped. Choose your mode above. With Scope only, the no-scope gyro sliders are not used and are marked as such.
Why does the frame rate change my sensitivity?
At 30-40 FPS the camera updates fewer times per swipe, so high values feel jumpy and sprays scatter. The generator lowers values by about 6-8% at 30-40 FPS and raises them slightly at 120 FPS.
Does this work for BGMI?
Yes. BGMI uses the same sensitivity system as PUBG Mobile, so the values apply directly.